ESPEmulator

Chip

No image yet

Loading emulator — —

Setup

Target

Firmware

Drop a merged flash .bin or choose a file

Where the file comes from

From an ESP-IDF project, run idf.py merge-bin. The image is usually build/merged-binary.bin. Pick the chip you compiled for.

ROM ELF

The embedded mask ROM is used unless you need a different silicon revision.

SSID

Password

Firmware that joins gets an association and a DHCP lease. Packets leave the tab only through the proxy below.

Applied when the image loads. Reload after you edit these.

WebSocket URL

Bridges Wi-Fi frames to a TAP interface on your machine via tools/ws-net-proxy.py.

One .bin with the bootloader, partition table, and app. ESP-IDF writes it with idf.py merge-bin.

Preparing the emulator…

Live

Speed

—

vs. real time

—

Emulated time

—

Cycles

—

MIPS, last 30 s

output high output low input high input low

Click an input pin to drive it. Pins the firmware configured as outputs show what it drives.

Registers for core 0 show up once an image is loaded.

Refresh while running

Enter an address and press Read. Unmapped bytes show as 00.